BEST ACCESS SYSTEMS 34HW Especificações descarregar pdf (Página 18)

Installation Instructions for 34HW–35HW IDH Max Mortise Locks

BEST ACCESS SYSTEMS

Indianapolis, Indiana

Installing the panel interface module

21 Connect field wiring from wire transfer

hinge to panel interface module

1 Connect the two communication field wires (run from

the wire transfer hinge) to the COM+ and COM–

terminals on the panel interface circuit board.

Note: The field wire harness leads, connected to the door

side of the wire transfer hinge, are described in the table

below.

2 If you are providing power to the lock through the

panel interface module, connect the two power field

wires (run from the wire transfer hinge) to the 12V and

GND terminals on the panel interface circuit board.

Note: JP2 and JP3, shown in Figure 21a, are used for

manufacturing purposes only.

3 Connect the RS-485 shield wire to one of the GND

terminals on J1.

Wire Color

Ground Black

12 VDC Red

Com+ Orange

Com– Green

IDH Panel Interface

Figure 21a Panel interface circuit board

Figure 21b Connecting field wiring from the wire transfer

hinge

Connect to wire

transfer hinge.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

BEST ACCESS SYSTEMS 34HW Especificações Página 18