BEST ACCESS SYSTEMS 35HW Manual de Serviço descarregar pdf (Página 144)

Additional Service and Maintenance for IDH Max Locks

6–4 W Series Service Manual

6. Loosen the screw holding the harness clamp and remove the clip.

Save the clip.

7. Disconnect the reader wire harness from the reader circuit board.

Reinstalling the reader wire harness

1. Connect the reader wire harness to the reader circuit board.

2. Slide the harness clamp under the loosened screw. Tighten the

screw. See Figure 6.2.

3. For magnetic stripe swipe and proximity card readers, peel away

the protective backing from the edge of the escutcheon gasket and

slide the gasket onto the upper escutcheon post. Press the gasket

into place on the edge of the escutcheon so the reader circuit board

is covered.

4. Connect the reader wire harness to the control electronics circuit

board. For mortise instructions, see Task E. To connect the reader

wire harness: on page 4–17. For cylindrical instructions, see

Tighten the RQE rose liner on the door with the through-bolts. on

page 5–12.

5. Reinstall the outside escutcheon. For mortise instructions, see

Task F. To secure the escutcheons and complete the connections:

on page 4–20. For cylindrical instructions, see Task G. To secure the

escutcheons and complete the connections: on page 5–15.

6. Reinstall the inside lever/knob. For mortise instructions,

see Task G. To reinstall the inside and outside levers/knobs: on

page 4–21. For cylindrical instructions, see Task H. To reinstall the

inside and outside levers/knobs: on page 5–16.

Figure 6.2 Removing the harness clamp

Harness clamp

Reader wire harness

Lower left mounting screw

Control electronics circuit board

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 227 228

Sem comentários

BEST ACCESS SYSTEMS 35HW Manual de Serviço Página 144