BEST ACCESS SYSTEMS 35HW Manual de Serviço descarregar pdf (Página 150)

Additional Service and Maintenance for IDH Max Locks

6–10 W Series Service Manual

Reinstalling the reader circuit board assembly

1. For locks with a magnetic stripe swipe card reader, connect the

reader harness to the reader circuit board and position the circuit

board in the outside escutcheon.

For locks with a proximity card reader, align the connectors on

the back of the reader circuit board assembly with the reader pins.

Press the board into place.

2. Loosely install the two reader electronics mounting screws.

3. Position the harness clamp under the left reader electronics

mounting screw. Make sure the reader wire harness is positioned

properly under the harness clamp. Tighten the screws.

4. Remove the backing from the adhesive tape and apply the tape to

the back of the outside escutcheon.

5. Press the sounder in place on the tape.

6. Peel away the protective backing from the edge of the escutcheon

gasket and slide the gasket onto the upper escutcheon post. Press

the gasket into place on the edge of the escutcheon so the reader

circuit board is covered.

7. Connect the reader wire harness to the control electronics circuit

board. For mortise instructions, see Task E. To connect the reader

wire harness: on page 4–17. For cylindrical instructions, see

Tighten the RQE rose liner on the door with the through-bolts. on

page 5–12.

8. Reinstall the outside escutcheon. For mortise instructions, see

Task F. To secure the escutcheons and complete the connections:

on page 4–20. For cylindrical instructions, see Task G. To secure the

escutcheons and complete the connections: on page 5–15.

9. Reinstall the inside lever/knob. For mortise instructions,

see Task G. To reinstall the inside and outside levers/knobs: on

page 4–21. For cylindrical instructions, see Task H. To reinstall the

inside and outside levers/knobs: on page 5–16.

10. Reinstall the core and throw member. For mortise instructions, see

Task H. To reinstall the core (EEL and EEU only): on page 4–23.

For cylindrical instructions, see Task I. To reinstall the core and

throw member: on page 5–17.

11. Making sure that the access door does not pinch any wires, insert

the tabs of the access door into its mating slots and swing the door

closed. Use the appropriate bit driver to secure the access door with

the security screw. Tighten firmly.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 227 228

Sem comentários

BEST ACCESS SYSTEMS 35HW Manual de Serviço Página 150