BEST ACCESS SYSTEMS 35HW Manual de Serviço descarregar pdf (Página 154)

Additional Service and Maintenance for IDH Max Locks

6–14 W Series Service Manual

Reinstalling the magnetic stripe insertion card reader

1. Position the card reader in the outside escutcheon and secure it

with the two reader electronics screws. Do not tighten the left

screw.

2. Connect the reader wire harness to the circuit board on the card

reader.

3. Position the harness clamp under the left reader electronics screw.

Tighten the screw.

4. Connect the reader wire harness to the control electronics circuit

board. For mortise instructions, see Task E. To connect the reader

wire harness: on page 4–17. For cylindrical instructions, see

Tighten the RQE rose liner on the door with the through-bolts. on

page 5–12.

5. Reinstall the outside escutcheon. For mortise instructions, see

Task F. To secure the escutcheons and complete the connections:

on page 4–20. For cylindrical instructions, see Task G. To secure the

escutcheons and complete the connections: on page 5–15.

6. Reinstall the inside lever/knob. For mortise instructions,

see Task G. To reinstall the inside and outside levers/knobs: on

page 4–21. For cylindrical instructions, see Task H. To reinstall the

inside and outside levers/knobs: on page 5–16.

7. Reinstall the core and throw member. For mortise instructions, see

Task H. To reinstall the core (EEL and EEU only): on page 4–23.

For cylindrical instructions, see Task I. To reinstall the core and

throw member: on page 5–17.

8. Making sure that the access door does not pinch any wires, insert

the tabs of the access door into its mating slots and swing the door

closed. Use the appropriate bit driver to secure the access door with

the security screw. Tighten firmly.

Removing and

reinstalling the

proximity card

reader assembly

Removing the proximity card reader assembly

1. Remove the core and throw member. For mortise instructions, see

Task A. To remove the core: on page 4–3. For cylindrical

instructions, see Task A. To remove the core and throw member:

on page 5–3.

2. Remove the inside and outside knobs/levers. For mortise

instructions, see Task B. To remove the inside and outside

levers/knobs: on page 4–4. For cylindrical instructions,

see Task B1. To remove the keyed lever/knob: on page 5–3.

3. Use the appropriate bit driver to remove the security screw from the

access door. Open the access door and remove it from the inside

escutcheon.

4. Remove the outside escutcheon. For mortise instructions, see

Task D. To disconnect the connections and remove the outside

escutcheon: on page 4–6. For cylindrical instructions, see Task D.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 227 228

Comentários a estes Manuais

Sem comentários

BEST ACCESS SYSTEMS 35HW Manual de Serviço Página 154

Comentários a estes Manuais

Manuais e produtos relacionados com Controladores de porta de segurança BEST ACCESS SYSTEMS 35HW